How To Miata Speed Your Miata

Located here are the "how To" projects you can do yourself!!

Welcome to the "How To" Page of Miata Speed

Please as see my posts at www.mazda-speed.com under the
complete how-to section

Installing a
mechanical boost
gauge
click photos to enlarge

Step 1:Tools needed,
multitool, wire stripper,
electrical tape, wire
taps, screwdriver, and
teflon tape <not shown>

Step 2: Remove the two
bolt shown in red and
remove this panel.

Step 3: Remove your
brightness switch by
pushing it out from
behind

Step 4: Remove the
connector from the back of
the switch and pull it out
so you can work with it.

Step 5: Add connectors
to the back of the light
wires for the boost gauge

Step 6: Using the crimp on
splices connect positive to
red and ground to black.

Step 7: Push the trim ring
onto the gauge, pop in
the light, and attach the
vacuum fittings to the
gauge with Teflon tape

Step 8" Pull out the rubber
grommet <shown removed>
and route you vacuum line
though the new opening

Step 9: Tee into the line
that connects to the back
of the intake manifold
above the green valve.
Use Teflon tape and make
sure there are no kinks

Step 9: Sit back and enjoy
the results. The go for a
drive, but don't forget to
watch the road too!!

Need Help?? Use this form

Your name:

Your email address:

Is your boost gauge light
opposite to the dash
lighting?
if yes then check the box

Questions, Comments,
etc:

Welcome To
Miata Speed.com